Number of wafer		1
Poles		2
Positions		2
Changeover angle		30±3°
Changeover timing		Non shorting
Rotational torque		40±20mN·m
Actuator configuration		18-tooth serration
Actuator length		L: 15mm

Operating temperature range			-30℃ to +85℃
Rating (max.)/(min.) (Resistive load)			0.1A 16V DC/50µA 3V DC
Electrical performance	Contact resistance (Initial performance/After lifetime)		50mΩ max./150mΩ max.
	Insulation resistance		100MΩ min. 100V DC
	Voltage proof		100V AC for 1 minute
Mechanical performance	Terminal strength		5N for 1 minute
	Actuator strength	Rotational direction	0.5N·m
		Push direction	100N
	Wobble of actuator (load at the tip of shaft: 5N)	Measuring position from mounting surface	10mm
		Shaft wobble (max. value)	0.17mm max.
		Applicable mounting dimension	15mm
Durability	Operating life without load		10,000 cycles 100mΩ max.
	Operating life with load (at max. rated load)		10,000 cycles 150mΩ max.
Environmental performance	Cold		-40℃ 96h
	Dry heat		85℃ 96h
	Damp heat		40℃, 90 to 95%RH 96h

Minimum order unit (pcs.)	Japan	360
	Export	1,800

Dimensions

Mounting Hole Dimensions

Viewed from direction A in the dimensions.

Circuit Diagram and Dummy Terminals

1. Viewed from direction A. 2. For positions 2, 1 section consists of 2-poles.

Packing Specifications

Tray

Number of packages (pcs.)	1 case / Japan	360
	1 case / export packing	1,800
Export package measurements (mm)		400×270×290

Shaft Style

* 18-tooth Serration Shaft The shaft shows the position in which it is turned fully counterclockwise.

Details About Serration

(1) The mold dimensions of standard serration and the dimensions of test jigs are as shown in the figure at left.

(2) Position of the serration bottom When the shaft is turned fully counterclockwise, the position of the serration bottom is on the AA line.

(3) Slitting angle The slitting angle (position) is not specified.

Attached Parts

The following parts are included with the product.

Soldering Conditions

Reference for Dip Soldering Items Preheating temperature 100℃ max. Preheating time 60s max. Dip soldering Soldering temperature 260±5℃ Duration of immersion 5s max.

Reference for Hand Soldering Soldering temperature 350±10℃ Soldering time 3+1/0s

Notes are common to this series/models.

1. This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply.
2. All the axis are die casting shafts.
3. Please place purchase orders per minimum order unit (integer).
4. Products other than those listed in the above chart are also available. Please contact us for details.