Number of wafer 1
Poles 2
Positions 5
Changeover angle 30±3°
Changeover timing Non shorting
Rotational torque 70±30mN·m
Actuator configuration Flat
Actuator length L: 15mm
Operating temperature range -30℃ to +65℃
Rating (max.)/(min.) (Resistive load) 0.15A 12V DC/50µA 3V DC
Electrical performance Contact resistance (Initial performance/After lifetime) 50mΩ max./100mΩ max.
Insulation resistance 100MΩ min. 500V DC
Voltage proof 500V AC for 1 minute
Mechanical performance Terminal strength 5N for 1 minute
Actuator strength Rotational direction 1N·m
Push direction 100N
Wobble of actuator (load at the tip of shaft: 5N) Measuring position from mounting surface 10mm
Shaft wobble (max. value) 0.17mm max.
Applicable mounting dimension 15mm
Durability Operating life without load 10,000 cycles 70mΩ max.
Operating life with load (at max. rated load) 10,000 cycles 100mΩ max.
Environmental performance Cold -40℃ 96h
Dry heat 85℃ 96h
Damp heat 40℃, 90 to 95%RH 96h
Minimum order unit (pcs.) Japan 60
Export 240
 

Dimensions

Rotary Switch

Terminal Configuration

Rotary Switch

Circuit Diagram

Rotary Switch
 
1. Standard poles per step.
2. The following mark in the above table indicate a stopper with the shaft turned fully counterclockwise when viewed from direction A of the diagrams.

Packing Specifications

Bulk
Number of packages (pcs.) 1 case / Japan 60
1 case / export packing 240
Export package measurements (mm) 400×270×270

Shaft Style

* Flat Shaft
The shaft shows the position in which it is turned fully counterclockwise.

Attached Parts

Rotary Switch
 
The following parts are included with the product.

Soldering Conditions

Reference for Dip Soldering
ItemsPreheating temperature-
Preheating time-
Dip solderingSoldering temperature260±5℃
Duration of immersion10±1s

Reference for Hand Soldering
Soldering temperature350±10℃
Soldering time3+1/0s


Notes are common to this series/models.

  1. This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply.
  2. All the axis are cutting shafts.
  3. Please place purchase orders per minimum order unit (integer).
  4. Products other than those listed in the above chart are also available. Please contact us for details.