Part number

SKUBAAE010

2.4×1.4mm Compact Type with Projection Type (Surface Mount) SKUB Series
Water-proof Type
Dust-proof Type
MEMBERS ONLY

Basic information

Product Photo
Product Photo
Type
Surface mount
Operating force
1.6N
Operating direction
Top push
Travel
0.11mm
Product height
0.55mm
Operating life
500,000cycles
Initial contact resistance
500mΩ max.
Water-proof & Dust-proof Type
IP6X equivalent/IPX8
Dimensions(W×D×H)
2.4×1.4×0.55

Specifications

Series type
Sharp feeling type
Operating temperature range
-30℃ to +85℃
Absolute Maximum Ratings
50mA 12V DC
Rating (min.)
10μA 1V DC
Electrical performance
Insulation resistance
100MΩ min. 100V DC for 1 min.
Voltage proof
100V AC for 1 min.
Durability
Vibration
10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z for 2 hours respectively
Environmental performance
Cold
-40℃ 96h
Dry heat
90℃ 96h
Damp heat
60℃, 90 to 95%RH 96h
Minimum order unit(pcs.)
Japan
20,000
Export
20,000

Land Dimensions

Packing Specifications

Taping

Number of packages (pcs.)
1 reel
20,000
1 case / Japan
200,000
1 case / export packing
200,000
Tape width (mm)
12
Export package measurements (mm)
395×395×205

Soldering Conditions

Condition for Reflow
  1. Heating method
    Double heating method with infrared heater.
  2. Temperature measurement
    Thermocouple 0.1 to 0.2 Φ CA(K) or CC(T) at solder joints (copper foil surface). A heat resisting tape should be used for fix measurement.
  3. Temperature profile

(1) The above temperature shall be measured of the top of switch. There are cases where PC board’s temperature greatly differs from that of the switch, depending on the material, size, thickness of PC board’s and others. Care, should be taken to prevent the switch’s surface temperature from exceeding 260℃.
(2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.

  1. Allowable soldering time : 2 times Max.

  1. Do not washing the TACT Switch™.
  2. Prevent flux penetration from the top side of the TACT switch™.
  3. Switch terminals and a PC board should not be coated with flux prior to soldering.
  4. The second soldering should be done after the switch returns to normal temperature.

Members-Only Content

SKUBAAE010
MEMBERS ONLY
Product Drawing
Product Material List
F-S Curve

Notes are common to this series/models

  1. This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply.
  2. Please place purchase orders for taping products per minimum order unit (1 reel or a case).
  3. Protective structure :
    Assumes the switch is left alone without being operated. Under the specified conditions, dust and water ingress with a significant impact on the switch’s on-off function is prevented.
    IP68-level dust and water resistance is guaranteed for the switch alone and performance may not be guaranteed depending on the mounting conditions and usage.